Aviosys 9070 Manuel d'utilisateur télécharger pdf (Page 22)

- 22-

Ref#92550806002

Some uses of this function would be for systems or computers that require a shut

down time

Delay after action (Seconds): The number of seconds it takes the attached

devices to startup. Once those devices start, the Startup Action will be activated

to continue pinging or stop pinging.

Continue Ping: After start up Delay has been reached the start up action will

either Continue Pinging or Stop Pinging

Action: When the number of Ping Failures have been reached. The device can

be set to perform a Off, On, or Reset function.

Ping Interval (Seconds): The number of seconds between each ping

Ping Echo Wait (Milliseconds): The number of milliseconds the device will wait

for a response from the pinged device if no ping is detected within this time it will

be considered a ping failure.

Please view the example below for more details:

In the picture above:

1.) Power 1 Ping function is enabled for two websites

2.) The 9258xx will ping the web address www.sample.com & www.google.com

3.) If there is a response within the Ping Echo Wait the 9258xx will send

another ping signal the set Ping Interval which is 3 seconds for this

example.

4.) If the 9258xx does not receive a response from the device it will constitute a

Ping Failures.

5.) After 3 consecutive failure the device will go to the Action Delay section. In

this case the device will delay for 3 seconds.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Pas de commentaire

Aviosys 9070 Manuel d'utilisateur Page 22